As you might know from my Instagram posts, I've recently restored and cleaned my workshop. Under a lot of trash, covered in dust, I found an old railroad track. I had no idea it was there and obviously I had no use for it. For that reason I decided to make a small anvil out of it. I always wanted to have a small one.
First I went online and did some research about anvils. After I had an idea how it should look like I started to cut it in shape with the angle grinder. I milled the surfaces flat after a rough shaping with the angle grinder and drilled a hole in it. If you don't have access to a milling machine, you could also grind the surfaces clean with an angle grinder. Having the top surfaces finished I was able to start shaping the horn. First I cut of the biggest pieces with the angle grinder and then I started to shpae the horn. Rough shaping at first with the angle grinder, then smoothing out with a file and then sandpaper. To remove all the rust I decided to give it a quick sandblast. If you don't have access to a sandblaster you could also remove the rust with a wire wheel or just grind it all clean with the angle grinder. For rust protection I used cold bluing. I then sanded all the functional surfaces clean again. This also gave the whole thing a nice touch and some contrast.
I'm more than happy how it turned out and I can't wait to start using it on future projects.
I hope you like my work and the video.
My camera:
Panasonic HC-V180
If you have any questions about the process, machines i'm using or other stuff, just ask me in the comments. I read them all and i try to reply as soon as possible.
Sorry for my bad english, it's not my language. I try my best to improve my technical english.
Subscribe for more of my content. I'm uploading videos about mechanical stuff, as new creations and buildings and also restorations.
Thank you for watching :-)
First I went online and did some research about anvils. After I had an idea how it should look like I started to cut it in shape with the angle grinder. I milled the surfaces flat after a rough shaping with the angle grinder and drilled a hole in it. If you don't have access to a milling machine, you could also grind the surfaces clean with an angle grinder. Having the top surfaces finished I was able to start shaping the horn. First I cut of the biggest pieces with the angle grinder and then I started to shpae the horn. Rough shaping at first with the angle grinder, then smoothing out with a file and then sandpaper. To remove all the rust I decided to give it a quick sandblast. If you don't have access to a sandblaster you could also remove the rust with a wire wheel or just grind it all clean with the angle grinder. For rust protection I used cold bluing. I then sanded all the functional surfaces clean again. This also gave the whole thing a nice touch and some contrast.
I'm more than happy how it turned out and I can't wait to start using it on future projects.
I hope you like my work and the video.
My camera:
Panasonic HC-V180
If you have any questions about the process, machines i'm using or other stuff, just ask me in the comments. I read them all and i try to reply as soon as possible.
Sorry for my bad english, it's not my language. I try my best to improve my technical english.
Subscribe for more of my content. I'm uploading videos about mechanical stuff, as new creations and buildings and also restorations.
Thank you for watching :-)
Category
🦄
Creativity