Here you need Arduino uno board, step motor and its driver and a bread board. this is only to show the pin connections.
Category
🤖
TechTranscript
00:00 Hello everyone, welcome to SIR TV and today I'm trying to control a step motor
00:04 using Arduino and I need the breadboard for the connection and
00:09 this driver, okay, so
00:12 My connection I used pin number four seven eight and twelve. Okay, so it's very basic
00:19 You need the ground and positive five volts here. Then you are going to tap this
00:28 So once you are able to load the program we're going to try it
00:32 So far, I'm not done with the program yet, but I hope that this connection will work
00:39 So see you again. I'll update you once the code is
00:42 Fully written and when it's fully uploaded. Bye guys. See you again in my next videos
00:48 [BLANK_AUDIO]