Cheerson CX-20 40 minute motor upgrade
Cutting off the bullet connectors, soldering, using heat shrink tubing is much faster and neater. Wires end up long the way the SunnySkys ship. Having done both methods I see no big reason to mess with bullet connectors on this quad. Either way when done you must power up the quad, bind the transmitter, and check motor rotation using the upper shell arrow as a guide. On mine 3/4 were spinning the wrong direction. I had to go outside so it would bind with a GPS lock. Switch any two of the three wires to change motor direction. Then heat shrink whether using bullet connectors or not.\r
\r
\r
Real SunnySky motors, dont get fooled by fakes:\r
\r
\r
Optional bullet connectors matching ones on SunnySky: \r
\r
Nice heat shrink assortment: \r
\r
\r
Optional CA used as loctite: \r
\r
\r
Very good 10 props for your new motors:\r
\r
\r
While open coat the inside with Shoe GOO: \r
\r
\r
Real SunnySky motors, dont get fooled by fakes:\r
\r
\r
Optional bullet connectors matching ones on SunnySky: \r
\r
Nice heat shrink assortment: \r
\r
\r
Optional CA used as loctite: \r
\r
\r
Very good 10 props for your new motors:\r
\r
\r
While open coat the inside with Shoe GOO: \r