Contours cutting machine (BA-S 102)
The contour cutting machine BA-S102 is a set simply guided by hand following the model with help of the 6 mm diameter feeler gauge tracer.
The vertical movement of the block holder table is done by an electrical motor.
This block holder is equipped with a depression system, which cuts small pieces of foam without difficulties.
The block holder is a moving Plexiglas plaque with a horizontal movement.
The cutting tool is a 1.3 to 1.5 mm endless wire.
Length of cut : 1000 mm
Useful width : 1400 mm
Height of cut : 1000 mm
The vertical movement of the block holder table is done by an electrical motor.
This block holder is equipped with a depression system, which cuts small pieces of foam without difficulties.
The block holder is a moving Plexiglas plaque with a horizontal movement.
The cutting tool is a 1.3 to 1.5 mm endless wire.
Length of cut : 1000 mm
Useful width : 1400 mm
Height of cut : 1000 mm
Category
🤖
Technologie