Doing a proper Ni200 build for the DNA40, from start to finish

This video shows how to do a properly working build for use with the DNA40 chip in temperature control mode. The coil is a 2.5 mm internal diameter, 12 wrap, 28 gauge wire coil. The video shows the entire process unedited, including me vaping until the mod hits temperature protection, to prove that it works well easily and without any drama.

This build doesn't normally take this long to do, but I was trying to show exactly how it's done, and my camera's autofocus has been acting up lately. Also, at times, I tend to work with my hands off-camera. I'm afraid I'm not very good at doing videos, sorry about that... Nevertheless, I hope you'll find the video informative.